.epa.gov

Determine the amount of steam purchased, boiler efficiency, and either the emission factors provided by the steam supplier or the types of fuel that the steam supplier uses to generate the steam. If values for boiler efficiency are unavailable, a default of 80% is provided in the Calculator.

Read more

High-Performance HVAC | WBDG - Whole Building Design Guide

Nov 07, 2016 · Absorption chillers can be direct-fired, using natural gas or fuel oil, or indirect-fired. Indirect-fired units may use different sources for heat: hot water or steam from a boiler, steam from district heating, or waste heat in the form of water, air, or other gas.

Read more

Steam Generators and Fluid Heaters Clayton Industries

Clayton is an industrial steam boiler manufacturer of fired steam generators and fluid heater steam generators. Clayton's industrial process steam boilers are available in 18 sizes from 15 to 2000 Boiler Horsepower (150 to 20,000 kW) and 518 to 69,000 pounds of steam per hour (235 to 37,300 kg/hr).

Read more

Mitsubishi Power | Power Plants: Integrated Coal

Oxygen-blown coal gasification captures CO 2 from gas having a high CO 2 content of about 40% under pressure ranging from 2.5 megapascals to 3.0 megapascals (pre-operation CO 2 capture), so that the gas flow to be treated is lower than the CO 2 content to be captured (post-operation CO 2 capture) from the boiler exhaust gas.

Read more

40 CFR § 98.33 - Calculating GHG emissions. | CFR | US Law

(1) When a unit is a fluidized bed boiler, is equipped with a wet flue gas desulfurization system, or uses other acid gas emission controls with sorbent injection to remove acid gases, if the chemical reaction between the acid gas and the sorbent produces CO 2 emissions, use Equation C-11 of this section to calculate the CO 2 emissions from the

Read more

(PDF) Design standards _ CONFERENCE BUILDINGS, EXHIBITION

Boilers are used to generate steam or hot water and can be fired by natural gas, fuel oil, or coal. a. The following boilers have combustion efficiencies between 78% and 86%. Firetube steel boilers are constructed so that hot gases from the combustion chamber pass …

Read more

Read "Air Quality and Stationary Source Emission Control

Steam turbine-gas turbine combined cycles are currently being used commercially on medium sized boilers using natural gas as a fuel. However, plants using these cycles would be unable to use coal as a fuel (unless it were first gasified and the particulates removed); they do not operate at sufficiently high temperatures to get the high

Read more

Compre Special Project (PPE &IPE) | PDF | Boiler | Thermal

3. Steam, initially saturated at 2.05 MPa, passes through a 10.10 cm standard steel pipe for a total distance of 152 m. The steam line is insulated with 5.08 cm thickness of 85% magnesia. For an ambient temperature of 22C, what is the quality of the steam which arises at its destination if the mass flow rate is 0.125 kg steam per second?

Read more

Related Information